Please can you assist with this one.
I have never been able to get any of the newer processors with VCP to work with message port - until today - .It was an accident how I discovered this but this is what happens.
When the amazing Pico or indeed STM32 and Nucleo boards or any of the latest boards with USB VCP - have been programmed with the mp lib then absolutely nothing is seen at all in AM, it will just sit there for ever - this is after adding the device port of course.
However, before opening AM, if I go to ANY terminal program, Putty, Hyperterminal etc etc, even the Arduino IDE Terminal window and simply connect to the com port - you don't have to type anything at all - just open a session and then close it, nothing more. Then open AM and 3 seconds later the device shows perfectly in AM and works absolutely flawlessly afterwards,. I can close and restart AM with no issues and have more or less instant mp device connection on startup, until the usb device is reset and then it needs 'waking ' again.
Help please
?Once connected they work absolutely perfectly.
It would be really appreciated.
Joe